Table of Contents
Advertisement
Adding a Switch Closure Input, RS-232, or IR Interface
Step 2
Activate Interface
Press any button.
• All input LEDs will flutter, then
• Switch Closure Input Interface:
the Flash LED and Input 1 LED will alter-
nately flash.
RS-232 or IR Interface: the top and bottom
row of the display will alternately flash.
Input 4 LED will remain ON when the Switch
Closure Input Interface has been activated.
Display will flash 01 when the RS-232 Interface
or IR Interface are activated.
Step 3
Complete Interface activation
Press "Done" (
System Bridge OR press and hold the ACTI-
VATE CONTROLS button on any auxiliary
Repeater until the green ACTIVATE CON-
TROLS LED turns off (approximately 3 sec-
onds). The green ACTIVATE CONTROLS
LED on ALL auxiliary repeaters will turn off.
The AUXILIARY LED will remain on.
The green ACTIVATE CONTROLS LED on
ALL
Repeaters will turn OFF. The MAIN or
AUXILIARY LED will remain on.
• The Interface is now activated.
• To program the input channels on the Switch
Closure Input Interface, refer to the RadioRA
Setup Guide (P/N 044-001).
Setup Guide for the RadioRA Chronos System Bridge
button) on the Chronos
TM
®
93
Advertisement
Table of Contents
