Grafik Eye Interface - Lutron Electronics RadioRA RA-SBT-CHR Setup And Installation Manual

Returning Components to Default Factory Settings
GRAFIK Eye
®
Returning a GRAFIK Eye Interface or GRAFIK RA Control Unit to Default Factory Settings will
permanently delete all current programming information. Do not do this unless you are sure that it is
necessary. For more information call the Lutron Technical Support Center.
Step 1
Remove faceplate
Ensure that the Chronos
in Activate Controls Mode, or the ACTIVATE
REPEATER LED or ACTIVATE CONTROLS
LED on any Repeater is NOT ON before pro-
ceeding. If either LED is ON, press the corre-
sponding button until it's LED turns OFF
(approximately 3 seconds).
Remove the faceplate from the GRAFIK Eye
Interface or GRAFIK RA Control Unit.
ON/OFF
60 HZ
50 HZ
Interface and GRAFIK RA
System Bridge is not
TM
Setup Guide for the RadioRA Chronos System Bridge
Control Unit
®
Step 2
Return to Default Factory
Settings
Press and hold the ON/OFF button until the
orange LED begins to blink (approximately 5
seconds).
ON/OFF
60 HZ
50 HZ
The GRAFIK Eye/GRAFIK RA Control Unit
will turn ON and OFF a few times indicating
that the GRAFIK Eye Interface or GRAFIK RA
Control Unit has been returned to Default
Factory Settings. Reattach the GRAFIK Eye
Interface or GRAFIK RA Control Unit face-
plate.
97