Table of Contents
Advertisement
Installing the Chronos
Step 5
Plug in the AC Adapter to the
Chronos System Bridge
Step 6
Plug in the AC Adapter to wall
receptacle
Plug the AC Adapter into a 120 V
50/60 Hz wall receptacle.
If the Power LED above the power jack
?
labeled "PWR IN" is not on when powered,
ensure that the AC adapter is installed prop-
erly and that there is power at the receptacle.
If problem persists, call the Lutron Technical
Support Center at (800) 523-9466.
14
Setup Guide for the RadioRA Chronos System Bridge
System Bridge
TM
Note: When the Chronos System Bridge is
powered up for the first time, the following
screen should be shown on the LCD:
Main Repeater - - - - - - -
Bridge Systems - - - - - -
RS-232 Interface - - - - -
Help
Power
Jack
Step 7
Replace the cover by inserting the two tabs
on the back of the cover into the slots on the
Chronos System Bridge.
,
Gently press down on the front edge to
engage the snaps.
Chronos Configuration
No
No
No
Done
Replace port cover
Advertisement
Table of Contents
