Table of Contents
Advertisement
Adding a Switch Closure Input, RS-232, or IR Interface
Activating a Switch Closure Input Interface, RS-232
Interface, or Infrared (IR) Interface
The Switch Closure Interface has a 15 second
delay after applying power. During this time the
Power LED will blink. When the Power LED
stays ON, the unit is ready for operation.
Step 1
Begin Interface activation
From the Chronos
System Bridge (as a Main
TM
Repeater only):
Main Menu
System Setup
System Setup
Activate Aux Repeaters
Activate Controls
Address Usage
Diagnostics
Back
From System Setup, select Activate Controls
Activate Controls
Begin Activating
Controls in System 1
Zone Controls - - - - - - - -0
Master Controls - - - - - - 0
Help
The number of devices and Master Controls currently
in the system is displayed. These numbers will
update as new Zone Controls and Master Controls
are activated. The green ACTIVATE CONTROLS LED
on ALL Auxiliary Repeaters will turn ON.
92
Setup Guide for the RadioRA Chronos System Bridge
Help
Done
From a Repeater:
Press and hold the ACTIVATE CONTROLS
button on any Repeater until the green ACTI-
VATE CONTROLS LED turns ON (approxi-
mately 3 seconds).
The green ACTIVATE CONTROLS LED on
ALL Repeaters will turn ON.
Advertisement
Table of Contents
