Table of Contents
Advertisement
Whole-home Button Programming
Step 4
Select a GRAFIK Eye
For ROOM Phantom Buttons, select one of
the Scenes (1 through 4) on a GRAFIK Eye
Control Unit by turning that Scene ON.
For SCENE Phantom Buttons, select one of
the Scenes on a GRAFIK Eye Control Unit by
turning that Scene ON OR select the Off
Scene on the GRAFIK Eye Control Unit if it is
to be turned OFF when the Phantom Button is
activated.
While setting light levels
• GRAFIK Eye Control Units assigned to a
ROOM Phantom Button cannot be turned
OFF.
• GRAFIK Eye Control Units not assigned to
this Phantom Button cannot be turned ON.
Step 5
scene
®
Press "Continue" (
Phantom Buttons:
1. RM - Home
2. RM - Btn 2
3. RM - Btn 3
4. RM - Btn 4
Exit
Note: The system is still in Level Set Mode, as indi-
cated by the icon in the upper right hand corner of the
screen. The arrow on the right of the screen indicates
which Phantom Button is currently in Level Set Mode.
Use the
Button. Press "Select" (
Set Mode for the highlighted Phantom Button.
Repeat Steps 3 and 4 for any additional Phantom
Buttons.
Press "Exit" (
• Proceed to Setting Button Properties for
Phantom Buttons on page 46.
Setup Guide for the RadioRA Chronos System Bridge
Select next Phantom Button
button) to display the list of
Set Zone Levels
Select
and
buttons to highlight a Phantom
button) to enter Level
button) to exit Level Set Mode.
45
Advertisement
Table of Contents
