Table of Contents
Advertisement
Zone Setup
Assigning Load Types
Main menu
1. Enter programming mode.
2. Use the Master buttons to highlight
CCI Setup
"Zone setup" and press the
Zone setup
OK button to accept.
3. Use the Master buttons to highlight
"Load type". Press the OK button to
Zone Setup
accept. See "Setting Load Types"
table on the next page.
Load Type
4. Use the zone raise/lower buttons to
Non-Dim Load Type
choose the load type for that zone.
See the list on the next page for
supported load types. Press the OK
button to accept.
Load Type
5. The info screen will confirm that
Set zones
your load type has been saved.
6. E xit programming mode.
Saved
®
1
2
3
Assigning Non-Dim Load Type
Zones assigned to non-dim loads have three available configurations:
Main menu
CCI Setup
Zone setup
Zone Setup
Load Type
Non-Dim Load Type
Load Type
For additional information, see the complete installation and operation guide at www.lutron.com/qs
GRAFIK Eye
4
5
6
1
• LOFO: Last On, First Off
• FOFO: First On, First Off
• FOLO: First On, Last Off
S cenes made up of both dim and non-dim
load types will toggle the non-dim loads
before the dim loads in a "First" on/off
configuration, and after the dim loads in a
"Last" on/off configuration.
1. Enter programming mode.
2. Use the Master buttons to highlight "Zone
setup" and press the OK button to accept.
3. U se the Master buttons to highlight "Non-Dim
Load type". Press the OK button to accept.
See "Setting Load Types" table on the next
Set zones
page.
4. Use the zone raise/lower buttons to choose
the non-dim load type for that zone. (Zones
not programmed as non-dim will be displayed
as Unaffected.) Press the OK button to
accept.
Saved
5. The info screen will confirm that your load
type has been saved.
6. E xit programming mode.
QS Control Unit Quick Installation and Operation Guide 12
®
Master
buttons
OK
OK button
2
3
4
5
6
Use the
zone
raise/lower
buttons to
choose the
load type for
that zone.
Advertisement
Table of Contents
