Table of Contents
Advertisement
RS-232 Port Programming
Assigning Zone Numbers
Zone Numbers are only necessary if the Chronos
vidual zones or if RS-232 feedback is desired when a zone changes. Prior to assigning zone numbers, fill out the
Zone Number worksheets (for each system) found in the RadioRA
(P/N 044-038).
Step 1
Go to Device Number Setup
Main Menu
RS-232 Setup
Device Number Setup
Note: If the Chronos System Bridge is bridging two
systems, device number setup must be done for each
system. Device Number Setup will appear as below:
Device Number Setup
System 1 Device Numbers
System 2 Device Numbers
Back
Use
and
to highlight the system, and press OK
to proceed to the next step.
Step 2
Select a Zone Number to
assign
From Device Number Setup, select Assign Zone
Numbers.
Assign Zone Numbers
Zone Number - - - - - - - -
Zone is Unassigned
Help
Use
and
to change the Zone Number to be
assigned.
68
Setup Guide for the RadioRA Chronos System Bridge
System Bridge serial port will be used to directly control indi-
TM
Help
1
Done
RS-232 Protocol and Programming Guide
®
Step 3
Assign a Lighting Zone
Control to a Zone Number
Assign a Dimmer or Switch to the selected
Zone Number by turning the Dimmer or
Switch ON.
Dimmer
Assign a GRAFIK Eye
Unit to the selected Zone Number by chang-
ing the scene of the GRAFIK Eye/GRAFIK RA
Control Unit.
If the wrong Lighting Zone Control is assigned
to a Zone Number, simply assign the correct
Lighting Zone Control to the Zone Number.
OR
Switch
/GRAFIK RA
Control
®
TM
Advertisement
Table of Contents
