Table of Contents
Advertisement
Returning Components to Default Factory Settings
Dimmers
Returning a Dimmer to Default Factory Settings will permanently delete all current programming informa-
tion. Do not do this unless you are sure that it is necessary. For more information call the Lutron
Technical Support Center.
Step 1
Turn FASS
Ensure that the Chronos
not in Activate Controls Mode, or the ACTI-
VATE REPEATER LED or ACTIVATE CON-
TROLS LED on any Repeater is NOT ON
before proceeding. If either LED is ON, press
the corresponding button until it's LED turns
OFF (approximately 3 seconds).
Move the Front Accessible Service Switch
(FASS) to the OFF position, or unplug Dimmer
if it is a Lamp Dimmer.
Step 2
Turn FASS switch back ON
Press and hold the raise rocker and the pad-
dle switch while turning the FASS switch ON
(or plugging Lamp Dimmer in) until the LEDs
begin to chase upward.
If the LEDs chase downward, continue
with Step 3, then repeat Steps 1-3
again.
switch OFF
TM
System Bridge is
TM
Setup Guide for the RadioRA Chronos System Bridge
Step 3
Return to Default Factory
Settings
While the LEDs are chasing upward, simulta-
neously press and release the lower rocker
and the paddle switch.
The light that the Dimmer controls will turn ON
and OFF a few times indicating that the
Dimmer has been returned to Default Factory
Settings. The Dimmer will turn on to 50%
when the process is complete.
95
Advertisement
Table of Contents
