Table of Contents
Advertisement
Activating the System
Activate Auxiliary Repeaters
This procedure needs to be performed only if the Chronos
the Chronos System Bridge is not configured as a Main Repeater, skip this procedure. Repeaters must be in
their permanent location in order to be activated. Note: Additional Auxiliary Repeaters (up to 3 Repeaters total
per system) can be added to a system to increase range and improve reliability.
Ensure all system devices are powered up and operating prior to adding any Auxiliary Repeaters.
Step 1
Go to System Setup
Main Menu
System Setup
Note: If the Chronos System Bridge is configured to
bridge systems, the Main Menu will contain a
System 1 Setup and a System 2 Setup. These
steps should be repeated for both systems.
Step 2
Put the Chronos System
Bridge into Activate Repeater
Mode
From System Setup, select Activate Aux
Repeaters.
System Setup
Activate Aux Repeaters
Activate Controls
Address Usage
Diagnostics
Back
The number of repeaters currently in the system is
displayed. This number will update as new repeaters
are activated.
Activate Aux Repeaters
Begin Activating Aux
Repeaters in System 1
Auxiliary Repeaters - - - - 0
Help
20
Setup Guide for the RadioRA Chronos System Bridge
Help
Done
System Bridge is configured as a Main Repeater. If
TM
Step 3
Activate Auxiliary Repeater
Nearest to the Chronos
System Bridge
Press and hold the ACTIVATE REPEATER
button until the green
ACTIVATE REPEATER LED begins to flash
(approximately 3 seconds).
Green ACTIVATE REPEATER LED will stay
on when Repeater has been activated.
Step 4
Activate remaining Repeaters
Repeat Step 3 for each remaining Repeater, starting
with the next closest Repeater (maximum of 3
Auxiliary Repeaters).
If the ACTIVATE REPEATER LED on an
?
Auxiliary Repeater turns orange, consult the
Troubleshooting Guide.
Advertisement
Table of Contents
