Assigning/Unassigning An Ecosystem Device To A Zone - Lutron Electronics GRAFIK Eye QS Quick Installation And Operation Manual

With ecosystem
Table of Contents

Advertisement

Available languages

Available languages

EcoSystem Setup

Assigning/Unassigning an EcoSystem Device to a Zone

EcoSystem devices must be addressed on the system (see previous page) before
assigning or unassigning to a zone.
1. Enter programming mode.
Main menu
2. Use the Master buttons to highlight "EcoSystem" and press
Zone setup
the OK button to accept.
Zone setup
3. Use the Master buttons to highlight "Assign zones" and press
EcoSystem
the OK button to accept.
4. Use the Master buttons to scroll through the EcoSystem
EcoSystem
devices on the link. The selected device will flash, and the
info screen will display the device number and the number
Assign zones
of devices on the link. If the device is currently assigned to a
zone, the zone number will display at the bottom of the screen
Address All
and the LEDs for the zone will go on; otherwise, the info
screen will display "*Unassigned*".
Assign zones
• Press the zone raise button to assign the device to that
zone.
Ballast 2 / 23
• Press the zone lower button to unassign the device to that
zone.
*Unassigned*
5. Press the timeclock (back) button to return to the EcoSystem
menu. EcoSystem devices will return to normal levels.
Assign zones
6. Exit programming mode.
Ballast 2 / 23
Notes
Zone 3
• Devices that were previously assigned to a zone will be
removed from the old zone and assigned to the new zone
(each device can be assigned to only 1 zone at a time).
• Devices can be assigned only to zones set to EcoSystem load
type.
• Refer to the Zone Setup section for instructions on changing
load type.
®
1
9
2
10
3
11
For additional information, see the complete installation and operation guide at www.lutron.com/qs
GRAFIK Eye QS with EcoSystem Control Unit Quick Installation and Operation Guide 16
4
12
5
13
6
14
7
15
8
16
1
9
Master
buttons
9-16
1-8
OK
OK
button
Timeclock
(back) button
2
10
3
11
4
12
5
13
6
14
Zone LEDs
7
15
8
16
Use the
zone raise
or lower
button to
assign or
unassign an
EcoSystem
device to
that zone.

Advertisement

Chapters

Table of Contents
loading

Table of Contents