Erasing Local Button Programming - Lutron Electronics RadioRA RA-SBT-CHR Setup And Installation Manual

Advanced Local Programming

Erasing Local Button Programming

Erasing Local Button Programming will remove all Lighting Zone Controls assigned to a Master Control button.
Note: Erasing programming on the ALL ON or ALL OFF buttons will reassign all controls to these buttons.
Step 1
Begin Erasing Button
Programming
Simultaneously press the 2nd and 4th buttons
in the right most column until the upper right
LED begins to flash (approximately 3 sec-
onds).
38 Setup Guide for the RadioRA Chronos System Bridge
Upper right LED flashes.
Step 2
Select button to erase
Press and hold the button to be erased until
its LED begins to flutter (approximately 3 sec-
onds).
ALL ON ALL OFF
ALL ON ALL OFF
LED will flutter for only 3 seconds. Step 3 must
be initiated while the LED is still fluttering.
Note: The LED will
first flash (slower)
and then begin to
flutter (faster).