Setting Light Levels/Grafik Eye And Grafik Ra Scene Selection For Buttons - Lutron Electronics RadioRA RA-SBT-CHR Setup And Installation Manual

Local Button Programming
Setting Light Levels/GRAFIK Eye
Selection for Local Buttons
Lighting Zone Controls assigned to each button may be set to desired light levels to fit the mood or activity pro-
grammed. Dimmer light levels default to 100% for ROOM Buttons and 50% for SCENE Buttons. Switches default
to ON and GRAFIK Eye/GRAFIK RA Control Units default to Scene 1. For an overview of the Master Control
programming process, refer to page 25.
Step 1
Begin setting light
levels/selecting GRAFIK Eye
and GRAFIK RA scenes
Simultaneously press and hold the 1st and 5th
buttons in the right most column until the
upper right LED begins to blink (approximately
3 seconds).
Tabletop Master
Step 2
Select a Button
Press and release the button that you want to
program. Its LED will begin to blink.
Lighting Zone Controls that have been assigned to
that button will turn ON. Controls not assigned to that
button will turn OFF.
32 Setup Guide for the RadioRA Chronos System Bridge
OR
Wall Master
ALL ON
ALL OFF
Upper right LED blinks.
and GRAFIK RA
®
Step 3
Set light levels for Dimmers
and Switches
Go to any assigned Dimmer. Adjust this
Dimmer's programmed light level for the
selected button using the dimming rocker. For
SCENE Buttons, turn the Dimmer OFF if it is
to be turned OFF when this button is pressed.
Go to any assigned Switch. For SCENE
Buttons, turn the Switch OFF if it is to be
turned OFF when this button is pressed.
Step 4
Select a GRAFIK Eye/GRAFIK
RA scene
Go to any assigned GRAFIK Eye/GRAFIK
RA Control Unit. Select from pre-programmed
scenes (1 through 4) by turning that scene
ON. For SCENE Buttons, select the Off Scene
if the Control Unit is to be turned off when this
button is pressed.
Note: See Application Note #48 for details on
selecting Scenes 5-16.
Scene
®