Using Radiora Master Controls With Raise/Lower - Lutron Electronics RadioRA RA-SBT-CHR Setup And Installation Manual

Using RadioRA
On Master Controls equipped with Raise/Lower buttons, you can remotely adjust the light levels of all the
Dimmers, and GRAFIK Eye
How Raise/Lower works
The Raise/Lower buttons affect a specific Master
Control button. By default the upper right-hand button
on the Master Control. As an example, if the Dimmer
in the Kitchen were assigned to the upper right-hand
button on the Master Control, pressing the Raise but-
ton would increase the light level of the Kitchen's
Dimmer.
Note: Raise/Lower will work with Master Control but-
tons having Local Programming only. Whole-home
Buttons are unaffected by Raise / Lower.
Raise
Lower
How to change which Dimmers you raise
or lower
You can easily change which Master Control button is
affected by the Raise/Lower button, quickly tap twice
the Master Control button that you want to be affected
by the Raise/Lower buttons. That Master Control but-
ton's LED will blink for about 2 seconds to indicate
that the Raise/Lower buttons are now affecting that
Master Control button.
Tap twice
quickly
Master Controls with Raise/Lower
®
Control Units assigned to a particular Master Control button.
®
Setup Guide for the RadioRA Chronos System Bridge
How LED status is affected
If you Raise a Dimmer that is initially OFF, the Dimmer
will turn ON and increase its intensity to the desired
level. Three seconds after the Raise button is
released, the Dimmer's status will be broadcast to the
entire system. Any Master Control ROOM LEDs,
which have that Dimmer assigned to them, will turn
ON since that Dimmer is now ON. Any Master Control
SCENE LEDs, which have that Dimmer assigned to
them, will turn OFF since the lights are no longer at
their preset level for that SCENE.
System Functionality
The Raise/Lower buttons are designed to work with
RadioRA Dimmers and GRAFIK Eye Control Units
only. RadioRA Switches are not affected by
Raise/Lower. Dimmers or GRAFIK Eye Control Units
which have OFF as their preset level for a particular
Scene will not be affected by Raise/Lower commands
when the Raise/Lower buttons are affecting that
Scene. Dimmers cannot be lowered to OFF.
Note: The functionality described above pertains to
RadioRA Dimmers and Switches which shipped after
January 1, 2001 and GRAFIK Eye Interfaces which
shipped after February 1, 2001. Contact the Lutron
Technical Support Center at 1-800-523-9466 for infor-
mation on using Raise/Lower Master Controls with
older dimming devices.
103