MacDon R113 Assembly Instruction Manual page 78

UNLOADING AND ASSEMBLING THE MOWER CONDITIONER
7. Position driveline (A) onto tractor PTO shaft making
sure that driveline is approximately level.
8. Pull back collar on driveline (A) and push driveline until
it locks. Release collar.
9. Start tractor and raise hitch so that stand (A) is off
the ground. Shut down tractor and remove key
from ignition.
10. Remove inner hairpin (B) and pull lock (C) to
release stand.
11. Raise stand (A), rotate lock (B) clockwise to vertical
position, and re-engage lock (B) to hold the stand in
the storage location.
169821
Figure 5.122: Mower Conditioner Driveline
Attached to Tractor PTO
Figure 5.123: Hitch Stand
Figure 5.124: Hitch Stand
72
Revision D