Converting From Transport To Field Mode - MacDon R113 Assembly Instruction Manual

8.16.2 Converting from Transport to Field Mode

DANGER
Do not convert the machine into, or from, transport mode until you are certain that all persons, animals,
and objects are clear of the unit's rotational range.
1. Check that remote control switch is in transport
position (A). Light (B) on box should be off.
2. Operate the lift control lever (as if raising the mower
conditioner) to fully extend the lift cylinders (A)
and raise the cutterbar off the transport assembly
support (B). The carrier frame latch (C) will
automatically open.
3. Operate the steering control lever to rotate the mower
conditioner (A) clockwise (as if steering to the right).
The mower conditioner will stop when it reaches
operating position.
4. Continue operating the steering control lever to raise
the transport assembly (B) and lower the mower
conditioner (A) onto the field wheels.
169821
PERFORMING PREDELIVERY CHECKS
120
Figure 8.35: Transport Control Box
Figure 8.36: Transport Mode
Figure 8.37: Field Mode
Revision D