MacDon R113 Assembly Instruction Manual page 57

UNLOADING AND ASSEMBLING THE MOWER CONDITIONER
Installing Swing Cylinder
20. Remove shipping bag from pallet.
21. Retrieve 32 mm x 90 mm clevis pin (A) from
shipping bag.
22. Cut straps securing swing cylinder (B) to pallet while
supporting cylinder.
23. Maneuver cylinder (A) into position and install barrel
end of cylinder onto carrier frame with clevis pin (B).
Secure clevis pin with cotter pin (C).
24. Connect the tractor swing hoses (not shown) to the
pressure valve fittings (A) on the swing cylinder (B).
25. Prime the swing cylinder (B) to fill the cylinder with
hydraulic oil and release trapped air. Use the tractor
cylinder controls to fully extend and fully retract the
swing cylinder.
169821
Figure 5.68: Swing Cylinder
Figure 5.69: Swing Cylinder
Figure 5.70: Priming the Swing Cylinder
51
Revision D