MacDon R113 Assembly Instruction Manual page 69

UNLOADING AND ASSEMBLING THE MOWER CONDITIONER
8. Install the light assembly (A) onto header left end with
two M10 x 20 carriage bolts (B) and lock nuts from
shipping bag. Ensure amber lamp is toward front of
header and reflector faces outboard.
9. Carefully pull existing harness from opening (B) at
front of carrier. Do not disconnect harness at main
connector P1.
10. Use a draw tape (A) or equivalent to route connectors
P2 and P3 into opening (B) at front of carrier to
opening (C) adjacent to center-link.
NOTE:
If a conditioner swap is required before delivering
machine to customer, do NOT install wiring
harness onto header. Leave it inside carrier
frame and proceed to step
Otherwise, proceed to the following step.
11. Pull harness (A) with connectors P2 and P3 from
opening (B).
169821
18., page 64.
63
Figure 5.102: Header Left Side Lighting
Figure 5.103: Harness Routing
Figure 5.104: Light Harness
Revision D