MacDon R113 Assembly Instruction Manual page 28

UNLOADING AND ASSEMBLING THE MOWER CONDITIONER
4. Raise hitch off deck, back up until unit clears trailer, and slowly lower to 6 inches (150 mm) from ground.
IMPORTANT:
Take care not to contact the other machine if load is two-wide.
5. Take to storage or assembly area, and set hitch down securely on level ground.
6. Repeat for second hitch (if required).
7. Check for shipping damage and missing parts.
8. Approach mower conditioner (A) from back with
forklift (B) as shown, and slide forks into pallet as far
as possible.
9. Raise mower conditioner off deck.
IMPORTANT:
Take care not to contact the other machine if load is
two-wide.
10. Back up until unit clears trailer, and slowly lower to 6 in.
(150 mm) from ground.
11. Take to storage or set-up area, and set machine down
securely on level ground.
NOTE:
When possible, approach from the backside to
minimize potential for contacting the unit.
12. Repeat for second mower conditioner (if required).
13. Check for shipping damage and missing parts.
IMPORTANT:
Do NOT remove header from pallet until instructed.
14. Unload remaining pallets and boxes, and take to
assembly area.
169821
Figure 5.2: Unloading Header
22
Revision D