MacDon R113 Assembly Instruction Manual page 31

UNLOADING AND ASSEMBLING THE MOWER CONDITIONER
9. Attach spring (B) to spacer (A), position spacer into
joint weldment, and secure with M12 x 55 hex head
bolt (C) and flanged center lock nut (D).
10. Lift center top cover, attach spring (C) to spacer (A),
position spacer into shield pivots (B), and secure with
M12 x 100 hex head bolt (D) and flanged center lock
nut (E).
IMPORTANT:
Do NOT attach center cover to outboard covers.
NOTE:
Perform this step if endwise transport system will not
be installed.
11. Lift center cover (A) and install six M10 x 20 carriage
bolts and lock nuts (B) (three per side) to secure center
cover (A) to outboard covers (C). Tighten bolts.
169821
Figure 5.8: Spring Attached to Transport
Figure 5.9: Spring Attached to Transport and
Top Cover
Figure 5.10: Center Cover Assembly
25
Revision D