Installing Hydraulic Center-Link - MacDon R113 Assembly Instruction Manual

UNLOADING AND ASSEMBLING THE MOWER CONDITIONER
Installing Remote Control
22. Retrieve remote control box (A) with wiring harness
from shipment.
23. Place control box (A) on hitch temporarily.
24. Attach remote wiring harness (B) to connector (C) at
front of hitch.
25. Place box in tractor cab after mower conditioner is
attached to tractor.
Installing SMV Sign
26. Retrieve SMV sign that was previously removed.
27. Remove existing bracket (A) from SMV sign
and discard.
28. Retrieve new bracket (A), two M12 x 30 bolts and
M12 nuts from shipment bag.
29. Attach bracket (A) to left end float spring member with
M12 bolts (B) and nuts.
30. Attach sign (C) to bracket and secure with three M6
lock nuts (D) provided in shipment bag.

5.12.2 Installing Hydraulic Center-Link

The hydraulic center-link kit is supplied in a separate shipment. Refer to instructions supplied with the kit for
installation procedure.
169821
Figure 5.108: Remote Control
Figure 5.109: SMV Sign
Figure 5.110: SMV Sign
65
Revision D