Removing Shield: No Conditioner - MacDon R113 Assembly Instruction Manual

6.4 Removing Shield: No Conditioner

CAUTION
Ensure spreader bar is secured to the forks so that it
cannot slide off the forks or towards the mast while
detaching the shield from the header.
1. Attach a spreader bar (A) to a forklift or equivalent, and
attach chains to openings (B) on shield. Use a chain
rated for overhead lifting with a minimum working load
of 2500 lb (1135 kg).
DANGER
To prevent the shield from falling backward, ensure
lifting chains are secure and tight. Failure to do so
may result in death or serious injury.
2. Remove two M16 hex head bolts (A) from each
side of shield that secure it to header.
slightly forward to take load off bolts and to hold the
shield after the bolts are removed. Retain hardware
for reinstallation.
CAUTION
Stand clear when detaching the shield.
3. Lift shield (A) off header (B), and move it away from
work area.
169821
CHANGING THE CONDITIONER
Figure 6.21: Spreader Bar
Lift shield
Figure 6.22: Left Side of Shield Shown –
Right Side Similar
Figure 6.23: Shield
86
Revision D