MacDon R113 Assembly Instruction Manual page 30

UNLOADING AND ASSEMBLING THE MOWER CONDITIONER
4. Remove two M10 carriage bolts securing left-hand
deflector shield in shipping position.
5. Reposition deflector shield so the holes align with
the fixed shield, and secure with four M10 carriage
bolts (B) and hex head flange nuts.
6. Repeat for opposite deflector shield.
NOTE:
This step applies only if installing the endwise
transport system. Install endwise transport system
before installing top covers and spring. If not
installing the endwise transport system, skip
this step.
7. Retrieve bag 50181 from the manual case for the
necessary parts to complete this procedure.
8. Secure joint weldment (A) to link bracket (B) using
M12 hex head bolt and flanged center lock nut (C).
169821
Figure 5.6: Left-Hand Deflector Shield Shown –
Right-Hand Deflector Shield Opposite
Figure 5.7: Joint Weldment on Link Bracket
24
Revision D