MacDon R113 Assembly Instruction Manual page 70

UNLOADING AND ASSEMBLING THE MOWER CONDITIONER
12. Route harness (A) to light (B) on header as shown.
13. Retrieve P-clips, plastic clamps and cable ties from
shipping bag.
14. Remove bolts (C) on header at locations shown.
15. Secure harness (A) with P-clips and existing bolts (C),
and plastic clamp (D) into existing hole.
NOTE:
Harness for 16-foot header is secured with two
plastic clamps (D).
16. Secure harness (A) to light bracket with two
cable ties (E).
17. Push excess harness into carrier frame.
18. Use a draw tape (A) or equivalent to route connectors
P4 and P5 from opening at front of carrier to
opening (B) at back.
19. Route harness (A) from opening into light bracket (B)
and plug into light connectors.
20. Secure harness (A) to light bracket with two cable
ties (C).
21. Push excess harness into carrier frame.
169821
Figure 5.105: Harness Routing
Figure 5.106: Harness Routing
Figure 5.107: Transport Light
64
Revision D