Connecting Electrical Wiring Harness - MacDon R113 Assembly Instruction Manual

UNLOADING AND ASSEMBLING THE MOWER CONDITIONER
2. Connect two STEERING cylinder hoses (B) to the
tractor hydraulic receptacles.
Steering and Transport System, page 74
.
3. Connect two mower conditioner TILT cylinder hoses
(C) to the tractor hydraulic receptacles. Refer to Table
5.6 Mower Conditioner Tilt System, page
required with mechanical center-link.)

5.14.4 Connecting Electrical Wiring Harness

1. Ensure that Pin #4 (A) in the tractor receptacle is NOT
continuously energized (refer to your tractor operator's
manual, and if required, remove the appropriate fuse.
IMPORTANT:
Older model tractors may have Pin #4 (A) energized
as an accessory circuit; however, pin position (B)
is used to supply power to the mower conditioner's
brake lights.
2. Connect the mower conditioner wiring harness
connector (C) to the tractor receptacle.
NOTE:
The connector is designed to fit tractors equipped
with a round seven-pin receptacle (SAE J560).
3. If installed, retrieve endwise transport option control
switch box (A) from temporary location on mower
conditioner hitch, and place in tractor cab.
harness through hose support.
4. Make the necessary connection from the control switch
box to tractor power source.
169821
Refer to Table 5.5
74. (Not
Route
74
Table 5.5 Steering and Transport System
Control Lever Cylinder
Position Movement
Forward Extend
Backward Retract
Table 5.6 Mower Conditioner Tilt System
Control Lever Cylinder
Position Movement
Forward Retract
Backward Extend
Figure 5.127: Electrical Wiring Harness
and Receptacle
Figure 5.128: Control Switch
Mower
Conditioner
Direction
Right
Left
Mower
Conditioner
Movement
Lower
Raise
Revision D