Checking Roll Timing - MacDon R113 Assembly Instruction Manual

8.6 Checking Roll Timing

DANGER
To avoid bodily injury or death from unexpected
startup of machine, always stop engine and remove
key from ignition before leaving operator's seat for
any reason.
1. Lower mower conditioner fully, stop engine, and
remove key from ignition.
2. Open the right side driveshield, refer to
Driveshields, page 91.
3. Examine the four bolts (A) in slots of yoke plate (B)
on upper roll universal shaft. The timing is set during
assembly at the factory. Bolts should be approximately
centered in slots and should be tight.
NOTE:
Only three bolts shown in the illustration.
NOTE:
Roll timing should not require adjustment. If
further adjustment is required, refer to the
R113/R116 Pull-Type Rotary Disc Mower Conditioner
Operator's Manual.
169821
PERFORMING PREDELIVERY CHECKS
7.1 Opening
104
Figure 8.8: Right Side Driveshield
Figure 8.9: Bolts in Slots of Yoke Plate
Revision D