Repositioning Center-Link Top Anchor - MacDon R113 Assembly Instruction Manual
Pull-type rotary disc mower conditioner
Hide thumbs
Also See for R113:
- Operator's manual (294 pages) ,
- Assembly instruction manual (212 pages) ,
- Unloading and assembly instructions (166 pages)
Table of Contents
Advertisement
UNLOADING AND ASSEMBLING THE MOWER CONDITIONER
5.3 Repositioning Center-Link Top Anchor
Perform this procedure to reposition the center-link top anchor into working position.
1. Cut strapping (A) securing cutterbar to pallet (B).
2. Place forklift forks (B) under top beam and lift carrier
frame (A) slightly until pin at base of center-link anchor
is loose. Use a piece of wood (C) to protect paint
on frame.
3. Loosen jam nut (A) and fully loosen float springs (B).
169821
Figure 5.17: Strapping
Figure 5.18: Carrier
Figure 5.19: Float Spring
28
Revision D
Advertisement
Table of Contents
