8.16 Checking Endwise Transport System
This check is required only if the Endwise Transport System is installed.
The cam on the transport deploy/swing mechanism
assembly is factory-set to 116° (A), and the valve clearance
is set to 2-1/2 in. (63 mm) (B). It may be necessary to
adjust the cam angle and valve position if the endwise
transport system does not properly deploy.
1. Loosen two M10 jam nuts (A), two M10 hex flange
nuts (B), and rotate top bar (C) to achieve the proper
angle. Reposition cam as follows:
• Rotate counterclockwise if the tires deploy too
close to the header.
• Rotate clockwise if the tires go underneath
the header.
2. Tighten two M10 hex flange nuts (B) and two M10 jam
nuts (A).
169821
PERFORMING PREDELIVERY CHECKS
116
Figure 8.27: Transport Deploy/Swing
Mechanism Assembly
Figure 8.28: Transport Deploy/Swing
Mechanism Assembly
Revision D