MacDon R113 Assembly Instruction Manual page 51

UNLOADING AND ASSEMBLING THE MOWER CONDITIONER
7. Using a floor jack or equivalent, raise 2-point hitch
adapter (A) into position under the gearbox.
8. Maneuver adapter (A) so that pin (B) can be installed
to secure adapter to hitch.
9. Secure pin with bolt (C) and nut.
10. Remove floor jack, and remove remaining strapping
and pallet from hitch adapter.
11. Install springs (A) as shown.
12. Assemble PTO driveline male half (B) onto female half
on hitch gearbox. Push male half so that PTO shaft is
at its fully compressed length.
13. Locate driveline on hook (C).
14. Retrieve stand (A).
15. Position stand (A) under gearbox as shown, and install
hitch pin (B) to secure stand.
16. Install hairpins (C) to secure hitch pin (B).
17. Lower hitch onto stand.
169821
Figure 5.53: 2-Point Hitch Adapter
Figure 5.54: Driveline
Figure 5.55: Stand
45
Revision D