Attaching Aft Driveline - MacDon R113 Assembly Instruction Manual

UNLOADING AND ASSEMBLING THE MOWER CONDITIONER

5.6 Attaching Aft Driveline

This procedure describes the attachment of the driveline to the header drive gearbox.
IMPORTANT:
If a conditioner swap is required before delivery to the customer, do NOT perform this step at this time. Skip to
5.8 Installing Wheels, page 41
1. Remove two bolts (A) with spacers (B) at top of
aft gearbox.
2. Undo latches (C) securing driveshield cone (D) to
gearbox and remove cone.
screwdriver or equivalent to undo latches (C).
3. Remove strapping (A) securing driveline (B) to hitch,
and remove all packing material.
4. Slide cone (A) onto driveline with latches (B) towards
the gearbox.
5. Remove nut (C) and washer (E) from tapered pin (D)
and tap out pin from yoke with a hammer.
169821
If necessary, use a
36
Figure 5.34: Driveline Shield
Figure 5.35: Driveline Strapping
Figure 5.36: Clutch Driveline
Revision D