Predelivery Checklist - MacDon R113 Assembly Instruction Manual

Predelivery Checklist

Perform these checks and adjustments prior to delivery to your Customer. If adjustments are required, refer to the
appropriate page number in this manual. The completed Checklist should be retained by either the Operator or
the Dealer.
WARNING
Do NOT operate the machine with the driveshields open. High speed rotating components may throw
debris and could result in death or serious injury.
CAUTION
Carefully follow the instructions given. Be alert for safety-related messages that bring your attention to
hazards and unsafe practices.
Mower Conditioner Serial Number:
Table 1 R113/R116 Pull-Type Rotary Disc Mower Conditioner Predelivery Checklist
 Item
Check for shipping damage or missing parts. Be sure
all shipping dunnage is removed.
Check for loose hardware. Tighten to required torque
if applicable.
Check main drive belt tension.
Check header angle to middle of adjustment range.
Check header float.
Check tire pressure: Field tires – 30 psi (207 kPa),
optional transport tires – 80 psi (552 kPa)
Check wheel bolts are torqued to 120 ft·lbf (160 N·m).
Check side forming shields evenly set to
desired position.
Check rear baffle is about mid-position
(roll conditioner).
Check forward baffle lever is set to approximate
mid-position (finger conditioner).
Check rear baffle lever is set to approximate
mid-position (finger conditioner).
Check conditioner roll gap (roll conditioner).
Check conditioner roll tension (roll conditioner).
Check conditioner roll timing hardware is securely
tightened (roll conditioner).
Check that tall crop dividers are not installed for
road transport.
APT Serial Number:
Reference
2 Recommended Torques, page 5
8.2 Checking Drive Belt, page 100
8.4 Checking Header Angle, page 102
8.3 Checking Header Float, page 101
8.1 Checking Wheel Bolts, page 99
5.2 Setting Up Forming Shields, page 23
8.12 Checking Conditioner Baffle Settings, page 112
8.11 Checking Roll Gap and Roll Tension, page 111
8.6 Checking Roll Timing, page 104
5.12.3 Installing Tall Crop Divider, page 66
—
—
127