Installing Shield: No Conditioner - MacDon R113 Assembly Instruction Manual

6.5 Installing Shield: No Conditioner

CAUTION
Ensure spreader bar is secured to the forks so that it
cannot slide off the forks or towards the mast while
installing the shield.
1. Attach a spreader bar (A) to a forklift or equivalent and
attach chains to openings (B) on shield. Use a chain
rated for overhead lifting with a minimum working load
of 2500 lb (1135 kg).
2. Lift shield (C) and position it into header opening.
3. Carefully align pin (A) at each end of shield with lug (B)
on header, and lower shield so that pins (A) engage
lugs (B) on header.
4. Align mounting holes and install four M16 x 40 hex
head bolts (A) (two per side)(heads inside shield).
Secure with M16 center lock flanged nuts and torque
to 126 lbf·ft (170 N·m).
5. Remove lifting chains from shield and move lifting
device clear of work area.
6. Remove shipping wire from curtains (B) and pull down.
7. Remove pulley and bushing from gearbox (C) and
replace with shaft cover (D). Attach cover (D) with two
M10 x 25 hex head bolts (E) and washers.
169821
CHANGING THE CONDITIONER
Figure 6.24: Spreader Bar
Figure 6.25: Conditioner Pins
Figure 6.26: Left Side Shown –
Right Side Similar
87
Revision D