MacDon R113 Assembly Instruction Manual page 130

5. Position transport hitch (A) on mower conditioner hitch,
install pins (B), and secure with lynch pins.
6. Lift the mower conditioner hitch with jack, and attach
mower conditioner to truck.
a. Two-Point Hitch (not shown): Rotate stand to
storage position.
b. Drawbar Hitch: Remove jack (C) from working
position, store on hitch, and secure with pin.
7. Wrap safety chain around hitch and attach to truck
frame (A).
8. Connect electrical harness (B).
9. Check local laws for width regulations and lighting or
marking requirements before transporting on roads.
10. Do not exceed 20 mph (32 km/h).
169821
TRANSPORTING WITH A TRUCK
124
Figure 9.3: Transport Hitch Installed
Figure 9.4: Safety Chain and Electrical Harness
Revision D