Installing Electrical - MacDon R113 Assembly Instruction Manual

UNLOADING AND ASSEMBLING THE MOWER CONDITIONER
28. Retrieve ORFS-6 x ORB-8 elbow from hardware bag.
29. Remove plug at base of lift cylinder and install elbow
(A) as shown.
30. Connect hose (B) to elbow and tighten.
31. Tighten remaining connections.
32. Secure hose to cylinder with cable tie.
33. Retrieve ORFS-6 x ORB-8 connector (A), ORB-8
coupler (B) and plastic cap (C) from hardware bag.
34. At forward end of hitch, install connector (A),
coupling (B) and plastic cap (C) onto secondary lift
hose (D). Do NOT attach hoses to tractor at this time.
35. Lower jack and move it away from header.

Installing Electrical

Installing Light Assemblies
1. Disconnect the wiring harnesses at each light
assembly. Two connectors per assembly.
2. Remove right end light (A) and left end light (B)
assemblies from carrier. Retain hardware for right end
light only.
169821
Figure 5.96: Lift Cylinder
Figure 5.97: Lift Hose Fittings
Figure 5.98: Transport Lighting
61
Revision D