MacDon R113 Assembly Instruction Manual page 4

List of Revisions
Summary of Change
Added instruction to apply anti-sieze lubricant to wheel
spindle bore in leg casting before spindle installation..
General revisions to Installing Transport Assembly
installation procedure.
Revised fittings callouts.
Revised Figure titles.
Revised Tall Crop Divider installation.
General revisions to Endwise Transport conversion
procedures to improve readability.
Added instruction to remove top shield when
repositioning center-link top anchor.
Added instructions to "Performing Predelivery Checks"
chapter for checking conditioner gear box, mower
conditioner drive gearbox, forward and rear swivel
gearboxes, and cutterbar lubricant levels.
Added instructions to "Predelivery Checklist" topic for
checking conditioner gear box, mower conditioner
drive gearbox, forward and rear swivel gearboxes, and
cutterbar lubricant levels.
Added instructions for unbolting cutterbar doors from
centre channel frame and removing shipping wire from
cutterbar curtains.
169821
Location
5.8 Installing Wheels, page 41
Installing Components, page 48
Installing Fittings, page 54
Installing Electrical, page 61
5.12.3 Installing Tall Crop Divider, page 66
8.16.1 Converting from Field to Transport Mode, page
118
8.16.2 Converting from Transport to Field Mode, page
120
5.3 Repositioning Center-Link Top Anchor, page 28
8.7 Checking Conditioner Drive Gearbox Lubricant,
page 105,
8.8 Checking Mower Conditioner Drive Gearbox
Lubricant, page 106,
8.9 Checking Forward and Rear Swivel Gearbox
Lubricant, page 107, and
8.10 Checking Cutterbar Lubricant, page
Predelivery Checklist, page 127
5.11 Unpacking Curtains, page 46
ii
109.
Revision D