Setting Up Forming Shield For Roll Conditioner - MacDon R113 Assembly Instruction Manual

UNLOADING AND ASSEMBLING THE MOWER CONDITIONER
17. Remove shipping wires (A) securing curtains (B)
to covers (C). Allow curtains to unfold before
operating machine.

5.2.2 Setting Up Forming Shield for Roll Conditioner

Use these instructions to set up the forming shield on a machine with a roll conditioner.
1. Remove and discard bolt (A) securing deflector (B)
to frame.
2. Remove lynch pins from adjuster bar (C) and
remove bar.
3. Swivel deflector (B) to open position.
4. Install adjuster bar (A) as shown using hole on carrier
plate (B), and hole (C) closest to pivot in deflector (D).
5. Repeat above steps for opposite deflector.
169821
Figure 5.14: Forming Shield Curtain
Figure 5.15: Side Deflector
Figure 5.16: Adjuster Bar
27
Revision D