MacDon R113 Assembly Instruction Manual page 58

UNLOADING AND ASSEMBLING THE MOWER CONDITIONER
26. Cut straps securing transport assembly to pallet.
27. Slowly lower forklift until transport assembly wheel
spindles (A) are approximately 12 in. (305 mm) off
the ground.
28. Remove wheel bolts (B) from spindles.
29. Retrieve transport wheels and install wheels with wheel
bolts. Ensure valve stem faces outboard. Do not fully
tighten bolts.
30. Lower wheels to ground and back away forklift.
31. Torque wheel bolts to 120 ft·lbf (160 N·m) following the
tightening sequence shown.
Attaching Swing Cylinder
32. Open fittings on rear swing cylinder (A) and
hydraulically extend cylinder to approximately 56 in.
(1420 mm) between pins using the tractor swing hoses.
NOTE:
Ensure swing cylinder (A) has been properly
primed before securing clevis end (B) to transport
casting. Refer to Step
priming instructions.
33. Connect clevis end (B) to transport casting. Align holes
and install 32 mm x 90 mm clevis pin (C). Secure with
cotter pin (D).
169821
24., page 51 for cylinder
Figure 5.71: Transport Wheel
Figure 5.72: Tightening Sequence
Figure 5.73: Swing Cylinder
52
Revision D