UNLOADING AND ASSEMBLING THE MOWER CONDITIONER
5.4 Attaching Hitch to Carrier
1. Attach chain or sling (A) from lifting vehicle or hoist to
hitch (B), and raise it approximately 24 in. (610 mm)
off ground.
2. Cut banding (C) securing wood supports, and
remove supports.
3. Remove the two bolts securing wood support to hitch
pin (D). Discard bolts.
CAUTION
Hold pin before removing bolt to keep pin from
dropping to floor.
4. Remove bolt (A) and wood block (B) from top of pin,
and remove pin (D).
5. Install hitch pin (A) fully into hitch as shown.
169821
Figure 5.24: Lifting Hitch
Figure 5.25: Hitch Packing
Figure 5.26: Pivot Pin
31
Revision D