UNLOADING AND ASSEMBLING THE MOWER CONDITIONER
Installing Transport Alignment Control
34. Retrieve cam assembly (A), 32 mm x 90 mm clevis pin
and cam arm (B) from shipping bag.
35. Remove nuts (C) from assembly mounting bolts.
36. Locate cam assembly (A) onto cylinder plate (B) with
bolts picking up existing holes in plate. Install nuts (C)
and torque to 40–45 lbf·ft (55–60 N·m).
37. Locate cam arm (A) into cam assembly (B).
38. Attach cam arm (A) and cylinder clevis (C) to transport
casting (D) with clevis pin (E). Secure with cotter pin
(not shown).
NOTE:
Install washer (F) if there is play in clevis pin (E).
Ensure clevis pin extends far enough to secure
with cotter pin when washer is installed. If the
clevis pin fits snugly without the washer, discard
washer and secure with cotter pin.
169821
Figure 5.74: Alignment Controls
Figure 5.75: Alignment Control
Figure 5.76: Alignment Control
53
Revision D