MacDon R113 Assembly Instruction Manual page 61

UNLOADING AND ASSEMBLING THE MOWER CONDITIONER
1. Place a container or rag under fitting on hitch
steering cylinder.
2. Remove existing fitting at location (A) from block.
3. Retrieve ORFS-6 x ORB-6 connector (B) from shipping
bag and install into location (A).
4. Retrieve ORFS-6 tee (C) and install onto connector (B).
5. Retrieve ORFS-6 check valve (D) from shipping bag
and install onto tee (C).
IMPORTANT:
Ensure arrow on check valve points in
direction shown.
6. Retrieve ORFS-6, 90 degree elbow (E) from shipping
bag and install onto existing fitting on alignment
control (F) as shown.
7. Retrieve ORFS-6, 90 degree elbow (A) from shipping
bag and install as shown at location on selector
valve (B).
8. Retrieve ORFS-6 tee (C) from shipping bag and install
as shown onto existing fitting on selector valve (B).
Installing Lines and Hoses
NOTE:
Refer to 2 Recommended Torques, page 5
fitting installation details.
169821
Figure 5.79: Alignment Valve Fittings
Figure 5.80: Selector Valve Fittings
for hydraulic
55
Revision D