Checking Cutterbar Lubricant - MacDon R113 Assembly Instruction Manual

8.10 Checking Cutterbar Lubricant

DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove
the key from the ignition before leaving the operator's seat for any reason.
1. Park the mower conditioner on level ground.
2. Position header so the cutterbar is approximately level.
3. Shut down the mower conditioner and remove key.
4. Open the cutterbar doors.
Checking Cutterbar Lubricant
CAUTION
Exercise caution when working around the blades.
Blades are sharp and can cause serious injury. Wear
gloves when handling blades.
5. Use a level to ensure the cutterbar is level
in both directions.
conditioner accordingly.
6. Remove oil level inspection plug (A) and O-ring (B)
from cutterbar.
7. Check that lubricant level is even with the bore hole.
8. Replace oil level inspection plug (A) and O-ring (B).
169821
PERFORMING PREDELIVERY CHECKS
Raise or lower mower
109
Figure 8.16: Cutterbar Doors
Figure 8.17: Spirit Level on Cutterbar
Figure 8.18: Inspection Plug and O-ring
Revision D