MacDon R113 Assembly Instruction Manual page 35

UNLOADING AND ASSEMBLING THE MOWER CONDITIONER
4. Remove four M10 hex head bolts (A) and flat washers,
and remove top shield (B).
CAUTION
To avoid injury, keep fingers clear of opening at base
of anchor.
5. Remove pin (A) from center location and lower forks
on forklift.
NOTE:
Pin should slide out freely. Adjust forklift or move
carrier until pin is loose. Avoid using a hammer
to remove pin.
6. Install pin (A) and secure with washer (B) and cotter
pin (C). Move the carrier and anchor so the pin can be
installed in working location.
169821
Figure 5.20: Top Shield
Figure 5.21: Center-Link Anchor
Figure 5.22: Center-Link Anchor
29
Revision D