6.3.1 Installing Conditioner Drive
This procedure describes the installation of the conditioner drive components on a machine that was originally
supplied with no conditioner.
1. Retrieve bag of following parts from conditioner
shipment:
• Shaft Key
• Pulley
• Bushing with Three M10 Bolts
• Tensioner Assembly
• M16 Hex Head Bolt
• M16 Nut
• Two M10 Nuts
• Eye Bolt
• Hardened Washer
• Spring
2. Remove two screws (A) from cover (B) and remove
cover from gearbox shaft. Retain parts for future use.
169821
CHANGING THE CONDITIONER
Figure 6.18: Shaft Cover
84
Revision D