MacDon R113 Assembly Instruction Manual page 41

UNLOADING AND ASSEMBLING THE MOWER CONDITIONER
To install cylinder on unit with the endwise transport
system, proceed as follows:
8. Disconnect the hoses at the cylinder and cap off
openings on cylinder and hoses.
9. Reposition cylinder (A) at right side of hitch and attach
barrel end to lug (B) on hitch with pin (C). Secure with
washer and cotter pin (D).
NOTE:
Clevis end of cylinder will be attached to endwise
transport system casting when transport system
is installed.
169821
Figure 5.33: Steering Cylinder
35
Revision D