Installing Drawbar Hitch - MacDon R113 Assembly Instruction Manual

UNLOADING AND ASSEMBLING THE MOWER CONDITIONER

5.9 Installing Drawbar Hitch

If the mower conditioner will be attached to a tractor drawbar, proceed as follows: If the mower conditioner will be
attached to tractor 3-point hitch, refer to
1. Remove shipping wire or banding (A) securing
shipping blocks (B) at front of hitch, and remove blocks.
2. Remove shipping wire (A) from jack (B) on drawbar
hitch shipment, and remove jack from pallet.
3. Install at jack (A) location at front of hitch, and secure
with pin (B).
4. Swivel driveline and lower gearbox (C) so that
driveline (D) is facing forward.
5. Lower forklift until hitch is resting on hitch jack (A).
169821
5.10 Installing 2-Point Hitch (Cat. II) Adapter, page
Figure 5.45: Hitch End Packing
Figure 5.46: Jack Packing
Figure 5.47: Hitch
42
44.
Revision D