Installing Hydraulics - MacDon R113 Assembly Instruction Manual

UNLOADING AND ASSEMBLING THE MOWER CONDITIONER
39. Retrieve completion valve assembly (A) and three
M12 x 25 flanged hex head bolts from shipping bag.
40. Attach valve assembly (A) to standoffs (B) on rear
of carrier with three M12 x 25 flanged hex head
bolts (C) provided.
Installing Transport Selector Valve
41. Retrieve selector valve (A) from shipping bag.
42. Remove the middle two previously installed bolts (B)
from hitch pin.
43. Position valve (A) on carrier hitch pin as shown and
install two M20 x 65 bolts (B), hardened washers (C)
and nuts.
44. Torque bolts to 340 lbf·ft (461 N·m).

Installing Hydraulics

This section describes the installation of the transport hydraulic control system.
Installing Fittings
Several fittings need to be replaced to suit the control system hydraulics.
NOTE:
Refer to 2 Recommended Torques, page 5
fitting installation details.
169821
Figure 5.77: Control Valve
Figure 5.78: Selector Valve
for hydraulic
54
Revision D