Installing Options; Installing Endwise Transport System; Installing Components - MacDon R113 Assembly Instruction Manual

UNLOADING AND ASSEMBLING THE MOWER CONDITIONER

5.12 Installing Options

Install the following optional kits which may have been supplied with your header. Use the instructions supplied
with the kit, or as specified below:

5.12.1 Installing Endwise Transport System

This section describes the installation of the endwise transport system. The basic components are installed first,
the hydraulic systems are connected, and the lighting and signage are installed last.

Installing Components

This section describes the installation of the basic parts of the endwise transport system.
Installing Latch Assembly
1. Remove shipping banding and packing material from
latch assembly (A) on transport pallet, and remove
latch assembly.
2. Remove the two M20 mounting bolts (B) from
latch assembly.
3. Locate latch assembly (A) onto carrier frame as shown
and secure with the M20 bolts and nuts (B). Do not fully
tighten bolts as it may be necessary to adjust position
of latch assembly for proper operation.
169821
Figure 5.60: Latch Packing
Figure 5.61: Latch Assembly
48
Revision D