MacDon R113 Assembly Instruction Manual page 38

UNLOADING AND ASSEMBLING THE MOWER CONDITIONER
6. Remove M20 bolts (A) and nuts from carrier at the hitch
attachment location. Retain bolts.
7. Maneuver hitch pivot (C) into attachment location (D)
on carrier and line up pin with hole in carrier.
8. Slowly lower hitch while maintaining pin alignment
until pin is fully inserted. Use a large soft hammer if
necessary to seat pin.
169821
Figure 5.27: Carrier
Figure 5.28: Hitch to Carrier
Figure 5.29: Pivot Pin
32
Revision D