Attaching Steering Arm - MacDon R113 Assembly Instruction Manual

UNLOADING AND ASSEMBLING THE MOWER CONDITIONER

5.7 Attaching Steering Arm

This procedure describes the attachment of the steering arm to the header drive gearbox.
IMPORTANT:
If a conditioner swap is required before delivery to the customer, do NOT perform this step at this time. Skip to
5.8 Installing Wheels, page 41
1. Remove strapping (A) and packing material securing
steering arm (B) to hitch.
2. Lower arm (A) from under the hitch and slide the arm
weldment (B) off arm.
3. Install the arm
opposite orientation.
4. Position arm weldment (C) onto gearbox (D).
169821
weldment (C) onto
Figure 5.38: Steering Arm Strapping
arm in
Figure 5.39: Steering Arm
38
Revision D