Transferring The Data To Got (Using A Cf Card); Writing The Data Into A Cf Card - Mitsubishi Electric C70 Setup Manual

2.2.6 Transferring the Data to GOT (Using a CF card)

A CF card is also available for installing OS and transferring the project data.
Write OS and the project data into the CF card, and transfer the data to GOT.

2.2.6.1 Writing the Data into a CF card

(1) Mount a CF card in the personal computer.
Start GT Designer2 on the personal computer, and open the project. Select [Communication]-[To Memory Card...]
from the menu bar.
(Note) At starting GT Designer2, if the "New Project Wizard" dialog box appears, close the dialog box.
(2) Select and set "Boot Drive" and "Memory card".
For "Boot Drive", select the drive on GOT for booting with the project data and OS.
For "Memory card", select the drive assigned to the CF card in the personal computer.
(Note) The following two options are available for "Boot Drive":
If OS data and project data (drawing data) are larger than the capacity of built-in flash memory, select "A:
Standard CF card" for "Boot Drive".
For details, refer to the "GT Designer2 Version2 Basic Operation/Data Transfer Manual" (SH(NA)-
080529), Section 8.
Project data
A: Standard CF Card
C: Built-in Flash Memory
OS
A: Standard CF Card
C: Built-in Flash Memory
C70 Setup Manual
2.2 GT Designer2
53