Transferring The Data To Got (Using A Cf Card); Writing The Data Into A Cf Card - Mitsubishi Electric C70 Setup Manual

MITSUBISHI CNC
2 GOT Initial Setup

2.1.6 Transferring the Data to GOT (Using a CF card)

A CF card is also available for installing OS and transferring the project data.
Write OS and the project data into the CF card, and transfer the data to GOT.

2.1.6.1 Writing the Data into a CF card

(1) Mount a CF card in the personal computer.
Start GT Designer3 on the personal computer, and open the project. Select [Communication]-[To Memory Card...]
from the menu bar.
(Note) At starting GT Designer3, if the "New Project Wizard" dialog box appears, close the dialog box.
(2) Select and set "Boot Drive" and "Destination Memory Card".
For "Boot Drive", select the drive on GOT for booting with the project data and OS.
For "Destination Memory Card", select the drive assigned to the CF card in the personal computer.
(Note) The following two options are available for "Boot Drive":
If OS data and project data (drawing data) are larger than the capacity of built-in flash memory, select "A:
Standard CF card" for "Boot Drive".
For details, refer to the "GT Designer3 Version1 Screen Design Manual (Fundamentals)" (SH(NA)-
080866), Section 8.
26
Project data
A: Standard CF Card
C: Built-in Flash Memory
OS
A: Standard CF Card
C: Built-in Flash Memory